natural gas burner for forge/pot
Wednesday, March 17th, 2010 at
3:55 pm
my new burner in the prototype stage.. needs a better fan and soldering together
More Searchable Sites
- Lip reading mobiles are wunderbar, still at the prototype stage (video) | ObjectSoft.Net
- orangetech.info » Lip reading mobiles are wunderbar, still at the prototype stage (video)
- New Technology helps this Blind Soldier to “See” with his Tongue | Loopy Gadgets and consumer electronics
- Blind soldier can “see” with his tongue | Geek with Laptop
- IngoCar’s 170 MPG Lightweight Concept Looks Good on Paper : Gas 2.0
Tagged with: Burner • forge • gas • homemade • natural
Filed under: Gas Burner
Like this post? Subscribe to my RSS feed and get loads more!
Doesnt that cost alot of money to be using that much gas?
not with natural gas no.. and your gas room/central heater or gas water heater would use the same.. this just keeps it in a hotter more centralized flame (well uses a little more but the cost of natural gas is small, if you were on propane you would use more but you would also have higher pressure so you could NOT use low pressure hose, but you could get just as hot without the fan helping)
Awesome!
Great effort and innovation! I love that nice roar it had just before it went out, but is that garden hose your using? That hose can be eroded by propane, natural, and MAPP gas. It may serve you well for a while, but just be careful.
that is just a test rig and garden hose wont be used in the final setup, dont worry about that